News
  1. Home >
  2. Deco Cutter Grinder End Mills
Deco Cutter Grinder End Mills

Deco Cutter Grinder End Mills

The reader may consider plunging the cutter into the wheels face is a dubious method as it will duplicate any irregularities on it. This is correct but the cutter will only cut on the end mills tip by an amount equal to the feed rate per cutting edge probably no more than 0.05mm wide even for a roughing cut.

[email protected]

Hot News

Our products sell well all over the world, and have advanced technology in the field of crushing sand grinding powder.